Superior Solid Premier Red Oak Natural Low Sheen - 3/4" - Prefinished - $7. psf

MAINTAINING THE CORRECT HUMIDITY LEVEL IN YOUR HOME

(35-50% FOR SOLID AND 30-65% FOR ENGINEERED AND ENHANCED)

Relative Humidity (RH) is the ratio of the actual amount of water vapour contained in the air at a given temperature to the maximum amount of water vapour that the air at that same temperature can hold, expressed as a percentage.

Wood is a hygroscopic material and always contains water. It constantly exchanges water vapour with the air, picking it up when relative humidity is high, and giving it off when relative humidity is low. Since wood swells as it absorbs water, and shrinks as it releases water, both its moisture content and its dimensions are controlled by the relative humidity of the surrounding air. Wood moisture content is equal to the weight of water contained in the wood divided by the oven dry weight of the wood, expressed as a percentage.

Inside homes however, where the relative humidity of outdoor air is drawn inside and drastically altered by heating and cooling without humidification or dehumidification, wide seasonal swings in relative humidity will cause wood moisture content and dimensional changes to occur. Since warm air can hold more water vapour than cold air, the relative humidity of air with a certain absolute humidity can be changed by simply changing its temperature. Gapping and cupping are common results of improper relative humidity and moisture content for solid wood floors. If in winter, for example, outside air is at 20oF and 65% RH is drawn inside and warmed to 70oF without humidification, its relative humidity drops to about 10%. In summer, outside air at 70oF and 60% RH that flows into a basement at 60oF will end up at 82% RH.

Low relative humidity: Solid hardwood flooring installed in a house with low humidity will start to show gaps between the boards. This is strictly a cosmetic issue and does not affect the structural integrity of the product. When the humidity returns to it’s recommended range, these gaps should start to disappear. If the gapping is extreme because the humidity was way below the recommended range, this will take more time to correct itself.

High relative humidity: If the humidity is too high in the house, the most common issue with solid hardwood floors is cupping. This damage can be either temporary (seasonal) or permanent depending on its extremity and the duration of the time it was exposed to high moisture. During this time of high humidity, the floor boards will expand. This expansion can exasperate the gapping during the winter months as the boards will not move back to their original location once they have been forced to move.

Low relative humidity: If the relative humidity is below 30% for a prolonged period, the face lamella will start to contract. This can cause what is called dry cupping and is considered normal when relative humidity is too low. The floor should return to its normal state once the relative humidity is back to normal (30-65%). If the relative humidity drops below 20%, the construction of Superior Engineered Flooring and Enhanced Hardwood Flooring is such that the core material will minimize the face lamella’s contraction. If the lamella is under too much stress, and the core is not allowing the face to move (minimize cupping) the face lamella has no other choice but to relieve its pressure by stress cracking. Stress cracking is NOT covered under this warranty.

High relative humidity: In Engineered and Enhanced Flooring, if the relative humidity is too high, the flooring will start to crown. Once the relative humidity goes back to within the specified range, it can should settle down and return to it’s original state.

DISCLAIMER: Failure to follow these recommendations can and will void your warranty. Refer to our warranty for any more information and exclusions.

Relative Humidity variations can be minimized with proper ventilation, humidification or heating. You may need to improve your humidification and/

or dehumidification system in order to maintain the required humidity levels.

Low relative humidity: If the relative humidity is below 30% for a prolonged period, the face lamella will start to contract. This can cause what is called dry cupping and is considered normal when relative humidity is too low. The floor should return to its normal state once the relative humidity is back to normal (30-65%). If the relative humidity drops below 20%, the construction of Superior Engineered Flooring and Enhanced Hardwood Flooring is such that the core material will minimize the face lamella’s contraction. If the lamella is under too much stress, and the core is not allowing the face to move (minimize cupping) the face lamella has no other choice but to relieve its pressure by stress cracking. Stress cracking is NOT covered under this warranty.

High relative humidity: In Engineered and Enhanced Flooring, if the relative humidity is too high, the flooring will start to crown. Once the relative humidity goes back to within the specified range, it can should settle down and return to it’s original state.

DISCLAIMER: Failure to follow these recommendations can and will void your warranty. Refer to our warranty for any more information and exclusions.

Relative Humidity variations can be minimized with proper ventilation, humidification or heating. You may need to improve your humidification and/

or dehumidification system in order to maintain the required humidity levels.

WARRANTY:

All Superior Hardwood and Engineered Products come with a LIFETIME STRUCTURAL Warranty and a 35 YEAR FINISH WARRANTY.

This warranty is available to the original purchaser of the product and is limited to the repair, refinishing, or replacement of the defective board or boards. If an acceptable resolution is not possible, Herwynen Sawmill Ltd. will refund the original purchase price of the defective floor. 

This is done on a pro-rated basis, based upon the proportion of the floor that is determined by Herwynen Sawmill Ltd., acting reasonably, to be defective. This warranty will be null and void if any replacement or attempts to repair are conducted without the knowledge and approval of Herwynen Sawmill Ltd. 

Herwynen Sawmill Ltd. will not be liable for any consequential or other additional damages beyond those stated above. 

The limitations on liability expressed in this document shall nevertheless apply to the relationship between the end user of this product and Herwynen Sawmill Ltd.

LIMITED STRUCTURAL WARRANTY

Every piece of Superior Flooring is subjected to many strict quality control inspections. Excluding

Superior Flooring: Warranty

Herwynen Sawmill Ltd. warrants to the original purchaser that it’s product in its original manufactured and purchased condition will be free from milling defects and structural deficiencies for the lifetime of the floor. This is the only structural warranty extended to the hardwood floor materials manufactured by Herwynen Sawmill Ltd. and all implied warranties including statutory warranties of any kind are expressly excluded.

WEAR LAYER WARRANTY

Herwynen Sawmill Ltd. warrants to the original purchaser that, under conditions which normally exist in a single-family residence, the finish wear layer of our pre-finished hardwood flooring will not wear through or peel from the wood for thirty- five years with the time calculated from the date of purchase by the original purchaser. This warranty is valid provided that regular maintenance as specified in this document is performed on a regular basis on the floor and the floor is properly installed. 

This is the only finish warranty extended to the hardwood floor materials manufactured by Herwynen Sawmill Ltd. and all implied warranties including statutory warranties of any kind are expressly excluded.

EXCLUSIONS

This warranty does not extend to or cover:

• Scratches, indentations, damage by neglect

or any other damage caused by improper handling, storage, installation, environmental extremes out side our acceptable ranges,

• Improper maintenance,

• Insufficient protection, misuse or

improper alterations of the original

manufactured product,

• Water damage,

• Fire damage,

• Improper installation,

• Improper use of infloor heating,

• Substandard subfloors,

• Discoloration due to variations in

the exposure to sunlight,

• Furniture transfer marks on the floor,

• Marks or damage from spiked heel

shoes, pets, and insects.

Furthermore, checking and cracking caused by improper moisture control is not covered by this warranty as all wood floors will expand and contract with the change of seasons.

In addition, your warranty will not be valid if our products are installed over an existing floor or a crawl space with an exposed earth floor, or improperly over radiant heat.

The damaged or otherwise unsatisfactory part of the floor which is subject to a claim under this warranty must be easily noticeable from a regular standing position, and cover at least 15% of the total floor area covered by the hardwood flooring in the application which is to be subject to a claim under this warranty.

CLAIMS INFORMATION

Claims are made first by contacting the dealer/ retailer from whom the product has been purchased. If such dealer is not able to resolve the problem, or they have determined that the issue at hand is a manufacturer’s defect, then that dealer must contact Herwynen Sawmill Ltd.

Claims will only be considered for review if an authorized Superior Flooring reseller contacts Herwynen Sawmill Ltd in this manner.

By making a claim against the warranty, the person claiming shall be deemed to acknowledge the right of Herwynen Sawmill Ltd to attend the premises in which the floor is installed and remove any samples required to determine the cause and condition for which the claim has been made.

REGISTRATION

This warranty will be null and void in the event that the product is not registered within 30 days of the purchase date.

You can register your warranty by visiting

superiorflooring.ca/warranty-registration

Experience timeless elegance with our Superior Solid Legacy White Oak Barewood Matte flooring. Crafted from premium 3/4" x 5" prefinished hardwood, this durable and stylish flooring features a natural white oak finish with a beautiful matte surface that enhances its authentic beauty. Perfect for adding warmth and sophistication to any space, this high-quality flooring is easy to install and maintain, making it an ideal choice for your home or office renovation. Elevate your interior design with the classic charm and superior craftsmanship of our Legacy White Oak flooring.

Returns:

Thank you for shopping with us!

Please note that we do not accept returns or exchanges.

We encourage you to carefully review your order details before completing your purchase.

If you have any questions or concerns about a product, our customer service team is here to help. We appreciate your understanding and thank you for choosing us!

Welcome to our White Glove Delivery Service!

We proudly offer premium white glove delivery within a 75-mile radius of Easton, Massachusetts. Our service includes all of Rhode Island, the South Coast, South Shore, North Shore, Metro Boston, Cape Cod, and Eastern Connecticut for only $200.

Our team will handle the delivery of your flooring products with care and professionalism, bringing them directly into the first floor of your home. Once your order is placed and your product arrives at our distribution center, we will contact you via email or text to confirm the delivery date. You will also receive a time window the day before the scheduled delivery to ensure convenience and flexibility.

Experience hassle-free, white glove service from start to finish. We look forward to helping you with your flooring needs!